Today we share some Operating Procedures for wide #web #slitting #machine.
1.Operators must be trained before starting their posts, and must be familiar with the use of different slitting machines. Equipment performance and general maintenance methods. Non-workers shall not operate at will.
2. Do a good job of labor protection before starting up, prepare some auxiliary tools and materials for operation (knife adjustment tools, cartons required by the job, paper tubes, paper cutters, tape, etc.) and place them in a suitable position on the machine.
3. Ensure that the equipment is in a safe state, turn on the electric and pneumatic switch, check whether the circuit is lacking phase and the gas circuit is unblocked, and try to run the machine to check whether the electric, pneumatic, and mechanical equipment are operating normally. Whether the protective facilities of the machinery are complete. During operation, prevent crushing, scratching, or bringing in rotating gears, chains, drums, etc.
4.Knife adjustment: adjust the accurate knife distance according to the job requirements, pay attention to the direction of the knife edge. If necessary, remove the bedknife and re-arrange the knife. If the knife is chipped or not sharp, it needs to be repaired and replaced.
5. Investigate the connection of static elimination facilities and the ground wire of the machine platform to ensure that the static electricity of the material is eliminated during operation. Lay waste paper under the machine to prevent dust absorption.
6. Pay attention to safety when loading. Push the material to a suitable position for inflation, and pay attention to the direction of rotation of the material.
7. Paper threading and edge alignment: thread the material from unwinding to rewinding according to the direction set by the equipment, and adjust the correction position for edge alignment. When trimming the edges, ensure that there is glue on both sides of the finished product, and pay attention to correction when feeding journey. Be sure to go to the middle of the deviation correction stroke. Pay attention to the correction side when running. When exceeds the route, the edge will not be cut and it should be dealt with immediately.
8. Put on the paper tube required by the job on the reel and align the materials. If you need to paste double-sided tape, you must paste the double-sided tape, adjust the appropriate winding tension and unwinding tension, and perform trimming and winding.
9. During the rewinding process, the quality of the product should be strictly inspected. Inferior products or waste products and other stolen goods or edge strips should not be rolled into the product. At the same time, the number of meters should be strictly controlled.
10. When stopping unloading, hold the material with one hand and pull the product out of the inflatable shaft. The material for the photo-painted surface must be worn with gloves, and no fingerprints should be left on the product.
11. According to the production requirements, complete the corresponding perfect packaging, including labeling plus wrapping paper or film, sealing and batch numbering, etc.
12. Turn off the power and air source after the machine stopped, and perform necessary cleaning and maintenance of the machine. Try not to scrape the excessive roller with a knife. The glue on the equipment should be wiped clean with a solvent.
13. If you encounter problems during the operation, in principle, stop the machine. If you cannot stop the machine for processing, you must slow down and deal with it carefully.
Learn more about our #slitting #machine,pls visit: https://www.linkedin.com/company/slitter-cutter-parts-components/
Written: Sonia wei
E-mail: sonia@makwell-mech.com
Whatsapp & wechat & mobile: 0086 13306265137
Comments
Post a Comment